![Polymers | Free Full-Text | Influence of Extruder’s Nozzle Diameter on the Improvement of Functional Properties of 3D-Printed PLA Products Polymers | Free Full-Text | Influence of Extruder’s Nozzle Diameter on the Improvement of Functional Properties of 3D-Printed PLA Products](https://pub.mdpi-res.com/polymers/polymers-14-00356/article_deploy/html/images/polymers-14-00356-ag-550.jpg?1642582996)
Polymers | Free Full-Text | Influence of Extruder’s Nozzle Diameter on the Improvement of Functional Properties of 3D-Printed PLA Products
![The Effects of Nozzle Bed Distance on 3D Prints - 3DPrint.com | The Voice of 3D Printing / Additive Manufacturing The Effects of Nozzle Bed Distance on 3D Prints - 3DPrint.com | The Voice of 3D Printing / Additive Manufacturing](https://3dprint.com/wp-content/uploads/2019/04/one-14.png)
The Effects of Nozzle Bed Distance on 3D Prints - 3DPrint.com | The Voice of 3D Printing / Additive Manufacturing
![This is by far the most universally helpful diagram I've found on the internet for getting started. For Nozzle height: adjusting filament flow gap. : r/3Dprinting This is by far the most universally helpful diagram I've found on the internet for getting started. For Nozzle height: adjusting filament flow gap. : r/3Dprinting](https://i.redd.it/p8tlco8po6oy.jpg)
This is by far the most universally helpful diagram I've found on the internet for getting started. For Nozzle height: adjusting filament flow gap. : r/3Dprinting
![Nozzle gap??? Is it supposed to touch the heat block? Tried tightening one of these at 240 degrees to get it to make contact but ended up snapping the nozzle. The heat Nozzle gap??? Is it supposed to touch the heat block? Tried tightening one of these at 240 degrees to get it to make contact but ended up snapping the nozzle. The heat](https://preview.redd.it/nozzle-gap-is-it-supposed-to-touch-the-heat-block-tried-v0-c8im8dtb4pi91.jpg?auto=webp&s=8db25d5ff80dc53fbe8bdeb04ca1ac440133a1c4)
Nozzle gap??? Is it supposed to touch the heat block? Tried tightening one of these at 240 degrees to get it to make contact but ended up snapping the nozzle. The heat
![Perfect Bed / Nozzle Levelling - Anet A8 - 3D Printing Tips - Tutorial - Please Read Description - YouTube Perfect Bed / Nozzle Levelling - Anet A8 - 3D Printing Tips - Tutorial - Please Read Description - YouTube](https://i.ytimg.com/vi/L6GJWHwrTmY/hqdefault.jpg)
Perfect Bed / Nozzle Levelling - Anet A8 - 3D Printing Tips - Tutorial - Please Read Description - YouTube
![Nozzle size-Gap-looking for a solution. I'm using a 0.6 nozzle and i'm getting a gap in my prints-in only 1 area. I tested various Cura settings but can't alter the gap-note the Nozzle size-Gap-looking for a solution. I'm using a 0.6 nozzle and i'm getting a gap in my prints-in only 1 area. I tested various Cura settings but can't alter the gap-note the](https://i.redd.it/2369oruqvzt41.jpg)